Three main points of July kiwi pruning

Topping started from the beginning of July, and the growth and development of kiwi new shoots gradually entered the peak period. At this time, the second topping should be carried out in time to prevent wind chopping, entanglement, control the long branches and promote the conversion of nutrients to fruits. For the second topping, the branches and vines should be entangled with each other. According to the strength of the growth potential, topping should be done around this period.

Thinning branches should be cleared and pruned in time from July to August. First remove the germinated long branches and diseased branches on the base and part of the main vines, and secondly remove the over-dense upright branches, cross branches, weak branches, and dorsal branches. The degree of thinning should be 10-15 centimeters above the mother branch. It is better to keep a new tip.

After fruit thinning is completed before July, during the growth and development of the fruit (July to September), the fruit and insect fruit, deformed fruit, sunburnt fruit, leaf ground fruit, small fruit, over-dense fruit, and damaged fruit are removed at any time. , Retain good fruits with good development and thick fruit stems. Principles of fruit retention: 4 to 5 fruit branches are retained for healthy and healthy growth, 2 to 3 fruit branches are retained for moderate results, and 1 for short fruit branches. From August to September, the leaf-fruit ratio is preferably 4:1.

Disclaimer: Some articles of this website are transferred from the Internet. If the legal rights of third parties are involved, please inform this website for processing. phone

Single Use Trocar Site Closure Device

A fascial closure device is a laparoscopic instrument used to close the fascia, the layer of tissue that covers and separates abdominal organs and muscles. The device is used during laparoscopic surgery to create a secure closure of the fascia after the surgical procedure is complete.

The fascial closure device consists of a needle and suture material attached to a handle. A needle is used to puncture the fascia, then suture material is passed through the puncture site and tied tightly to close the fascia. The device's handle is used to control the movement of the needle and suture material, allowing precise placement and closure of the fascia.

The use of fascial closure devices during laparoscopic surgery can help reduce the risk of postoperative complications such as hernias, wound infections, and intestinal obstruction. It also closes the fascia more quickly and efficiently, reducing the overall time required for the procedure.


Single Use Trocar Site Closure Device,Medical Use Fascial Closure System,Single Use Fascial Closure System,Exit Fascia Closure Device

Changzhou Weipu Medical Devices Co., Ltd. , https://www.wmlaparoscopic.com